-40%

CrystaLac Polyurethane Extreme Protection Waterbased Satin 32oz Quart

$ 20.32

Availability: 58 in stock
  • All returns accepted: ReturnsNotAccepted
  • Container Size: 1 Quart
  • MPN: Does Not Apply
  • Sheen: Satin
  • Condition: New
  • Brand: CrystaLac
  • Base Material: Water-Based
  • Country/Region of Manufacture: United States
  • Type: Water Based

    Description

    CrystaLac Polyurethane Extreme Protection Waterbased Satin 32oz Quart. Condition is "New". Shipped with USPS Priority Mail.
    CrystaLac Extreme Protection Polyurethane
    is an interior
    NON-YELLOWING
    , Environmentally Safe Top Coat that is Super Hard, Super Clear and Super Easy to Use. It is Scratch, Chemical, and Water Resistant. It
    Self-Levels
    , has Low Odor, Low V.O.C. and cleans up easily with water.
    Use anywhere an extra level of protection is needed. Added
    UV stabilizers
    will keep dyes and stains brilliant and will help protect colors from fading. Dries crystal clear even over white finishes. Excellent for use as a
    chalk paint sealer.
    CrystaLac Polyurethane can be applied by either
    brushing or spraying
    (gravity feed or HVLP sprayer) see website for detailed spraying instructions. Use a good quality brush.
    Prior to Top Coating, we recommend using CrystaLac Amber Toned
    Sanding Sealer
    to enrich the warm natural colors in the wood and minimize grain raising.
    It is
    not necessary to sand
    between each Top Coat. All CrystaLac Top Coats will bond to the prior coat. CrystaLac Top Coats can be used over thoroughly dried oil or water-based stains, shellac, lacquer, Polyurethane or Acrylic.  If recoating over an old finish, scuff sand first and remove any surface contaminants such as dirt, waxes or polishes.
    Usually
    3 to 5 coats
    are sufficient to produce a beautiful, protective finish. Use more if desired.
    Coverage
    is approximately 400 to 500 sq. ft. per gallon.
    Dry time
    is usually 30 min to 1 hour. Allow 2 to 4 hours before recoating.
    Do Not
    use stearated sandpaper or tack cloths.
    Do Not
    freeze
    . Do Not
    apply below 60 degrees.
    Do Not
    thin or clean with lacquer solvents or mineral spirits. Use soap and water for clean-up.
    Warranty:
    Test to your satisfaction on scrap material before using. The manufacturer, The CrystaLac Company, will only replace defective product. Under no circumstances will the manufacturer or distributors be responsible for the cost of application labor, refinishing expenses, or any costs more than the purchase price of the container.
    Caution:
    Keep out of reach of children! Do not ingest. Avoid contact with skin and eyes. Do not breathe vapors. Use with adequate ventilation. When spraying or sanding, use an OSHA approved mask. V.O.C. is less than 1.4 Lbs. per gallon.
    Disposal:
    Consult your local sanitation department. Do not dump on the ground.